Troy-Bilt 020241 Manual Del Propietário página 4

Section 1: Safety Rules
WARNING
DO NOT touch hot surfaces.
Allow equipment to coo[ before touching.
The pressure washer must be at [east 5 feet from structures
having combustible wails and/or other combustible materials.
Keep at least 3 feet of clearance on all sides of pressure
washer for" adequate cooling, maintenance and servicing.
In the State of California a spark arrester is required by law
(Section 4442 of the California PuNic Resources Code). Other
states may have similar Jaws. Federal laws apply on federal
lands. If you equip the muffler with a spark arrester; it must be
maintained in effective working orden
WARNING
. DO NOT wear loose clothing, ieweiry or anything that may
be caught in the starter or" other rotating parts.
. Tie up long hair and remove ]ewelD:
WARNING
Always wear eye protection when using this equipment or in
vicinity of where equipment is in use,
WARNING
1
WHEN ADJUSTING OR MAKING REPAiRSTOYOUR
PRESSURE WASHER
Disconnect spark plug wire from spark plug and place wire
where it cannot contact spark plug.
CAUTION
DO NOT tamper with governed speed.
DO NOT operate pressure washer above rated pressure.
CAUTION
DO NOT secure spray gun in open position.
DO NOT leave spray gun unattended while machine is
running.
NEVER use a spray gun which does not have a trigger lock or
trigger guard in place and in working order:
Always be certain spray gun, nozzles and accessories are
correctly attached.
DO NOT point spray gun at glass when using MAX (pin
point) nozzle,
NEVER aim spray gun at plants.
If you have questions about intended use, ask dealer or
contact Briggs & Stratton Power Products.
NEVER operate units with broken or missing parts, or
without protective housing or covers.
DO NOT by-pass any safety device on this machine.
Before starting pressure washer in cold weather, check all
parts of the equipment to be sure ice has not formed there.
NEVER move machine by pulling on high pressure hose. Use
handle provided on unit.
Check fuel system for leaks or"signs of deterioration, such as
chafed or" spongy hose, loose or missing damps, or damaged
tank or cap. Correct all defects before operating pressure
washerL
This equipment is designed to be used with Briggs & Stratton
Power Products authorized parts ONLY. ff equipment is used
with parts that DO NOT comply with minimum specificadons,
user assumes all risks and liabilities.