Remote Control Unit; Troubleshooting - Teac CR-H226 Manual Del Usuario

In case of trouble with the unit, please take the time to
look through this chart and see if you can solve the
problem yourself before you call your dealer or TEAC
service center.
Amplifier
No power
e Check the connection to the AC power supply.
No sound from speakers.
e Check the connection to the speakers.
e Adjust the volume.
e Select proper source.
e Pull out the headphone plug from PHONES jack.
e If muting is on, press the MUTING button.
The sound is noisy.
e The unit is too close to a TV set or similar
appliances. Install the unit apart from them, or
turn them off.

Remote Control Unit

Remote control doesn't work.
e If the batteries are exhausted, change the
batteries.
e Use remote control unit within the range (5m)
and point at the front panel.
e Clear obstacles between the remote control unit
and the main unit.
e If a fluorescent light is near the unit, turn it off.
Tuner
Cannot listen to any station, or signal is too
weak.
e Tune in the station properly.
e If a TV is near the unit, turn it off.
e Install the antenna again after locating the best
reception position.
e An external antenna is recommended.
Though the broadcast is stereo, it sounds
monaural.
e Press the FM MODE button.
38

Troubleshooting

CD Player
Cannot play.
e Load a disc with label side up.
e If the disc is dirty, clean the surface of the disc.
e A blank disc has been loaded. Load a prerecorded
disc.
e Unfinalized CD-R/CD-RW disc is not playable.
Finalize the disc properly.
Sound skips.
e Place the unit on a stable place to avoid vibration
and shock.
e If the disc is dirty, clean the surface of the disc.
e Don't use scratched, damaged or warped discs.
No program playback.
e In the stop mode press PROGRAM button to
enter the program mode, and press the PLAY
button (y) to start playing.
MP3/WMA
There is no sound even if the PLAY button (y) is
pressed.
e Check if there are MP3 or WMA files on the USB.
e Non-playable file formats (e.g MPEG 1 LAYER 2
file) cannot be played.
"No song title No artist No album" appears on the
display.
e There is no ID3 tag information for the music file.
Edit the song title, artist, and album information
of the song on a PC using the MP3 or WMA
making application.
Some unknown characters are displayed on the
display panel.
e This unit cannot display symbols and full-size or
double-byte characters (such as Japanese,
Chinese, etc.) correctly. File name of MP3 or
WMA should be alphanumeric characters.
If normal operation cannot be recovered, unplug
the power cord from the outlet and plug it again.