Additional Settings (Degauss/Cancel Moire); Resetting The Adjustments (Reset) - Sony Trinitron CPD-110EST Manual De Instrucciones

Additional settings (DEGAUSS/
CANCEL MOIRE)
You can manually degauss (demagnetize) the screen, and cancel
the moire.
1
Press the MENU button.
The main MENU appears on the screen.
Press the + + + + /− − − − buttons to highlight
2
CANCEL MOIRE and press the ENTER button.
The DEGAUSS/CANCEL MOIRE menu appears on the
screen.
3
Press the ENTER button to select the desired
adjustment item.
Adjust the selected item according to the following
instructions.
Degaussing the screen
The monitor is automatically demagnetized when the power is
turned on.
To manually degauss the monitor, first press the
ENTER button to select
+ + + + button.
The screen is degaussed for about 5 seconds. If a second degauss
cycle is needed, allow a minimum interval of 20 minutes for the
best result.
Cancelling the moire
If elliptical or wavy patterns appear on the screen, adjust the
moire cancellation level.
To adjust the amount of moire cancellation, first press
the ENTER button to select
press the + + + + /− − − − buttons until the moire effect is at a
minimum.
*
Moire is a type of natural interference which produces soft, wavy lines
on your screen. It may appear due to interference between the pattern
of the picture on the screen and the phosphor pitch pattern of the
monitor.
Example of moire
12
DEGAUSS/
(DEGAUSS). Then press the
(CANCEL MOIRE). Then

Resetting the adjustments (RESET)

This monitor has the following two reset methods. Use the
RESET menu to reset the adjustments.
1
Press the MENU button.
The main MENU appears on the screen.
Press the + + + + /− − − − buttons to highlight 0 RESET and
2
press the ENTER button.
The RESET menu appears on the screen.
Reset the settings according to the following instructions.
Resetting all of the adjustment data for the
current input signal (MODE)
Press the − − − − button.
The MODE item is selected. All of the adjustment data for the
current input signal is reset.
Note that the following items are not reset by this method:
• on-screen menu language (page 7)
• picture's rotation (page 11)
Resetting all of the adjustment data to factory
preset levels (ALL)
Press the + + + + button.
The ALL item is selected. With the exception of the USER
settings in the COLOR menu, all of the adjustment data for all
input signals is reset to the factory preset levels.
Note
'
The monitor s buttons will not operate for about 5 seconds when ALL is
selected.