Pioneer SE-DIR800C Manual De Instrucciones página 25

Additional information
Symptom
DIGITAL input
Indicator flashing.
DTS sources do not
play.
Distorted sound (or
noise).
Quiet sound.
The surround sound
effect is not obtained.
2D indicator does
not light up.
2PL II indicator does
not light up.
DTS indicator does not
light up.
The batteries will not
charge.
This system may not work properly due to external effects such as static electricity. Unplug
the AC power adaptor and plug it in again. If this does not correct the problem, please
consult your nearest Pioneer service center.
Cause and remedy
! This system supports 44.1kHz and 48kHz digital audio. Set the digital
output of your DVD player to 48kHz, or use the analog connection.
! Your source component must support DTS playback. Check the
operating instructions of the connected source component for DTS
compatibility.
! Set the ATT switch on the transmitter to -8dB.
! If you connected your source component to this system from the
headphone output, lower the volume level of the source component.
! Set the ATT switch on the transmitter to 0dB.
! If you connected your source component to this system from the
headphone output, raise the volume level of the source component.
! Raise the headphone volume.
! The DH mode is set to OFF.
! The audio being played is not multichannel. The surround sound effect
does not work for monaural sound sources.
! The digital audio output setting for the DVD player (including game
machines) is set to PCM. Refer to the operating instructions supplied with
the DVD player and change the setting to Dolby Digital.
! The source is not Dolby Digital encoded.
! The audio in the current chapter is not Dolby Digital encoded.
! The DH mode is set to OFF.
! The source is DTS encoded.
! The source is non-stereo Dolby Digital encoded.
! Dolby Pro Logic II is set to OFF.
! The DTS digital output setting on the DVD player (including game
machines) is set to OFF. Refer to the operating instructions supplied with
the DVD player and set the DTS digital output setting to ON.
! The source is not DTS encoded.
! The audio in the current chapter is not DTS encoded.
! The DVD player does not support DTS format. Use a DVD player that
supports DTS.
! Dry-cell batteries or rechargeable batteries other than the ones supplied
are being used. Use only the supplied rechargeable batteries.
! The rechargeable batteries are exhausted. Replace them with new
rechargeable batteries.
04
25
En