Using The Cooling Unit; Energy Saving Tips - Dometic Waeco ColdMachine CU-54 Instrucciones De Uso

Using the cooling unit

Connecting to a 230 V mains supply
Danger of fatal injuries!
e
Never handle plugs and switches with wet hands or if you are
standing on a wet surface.
Caution!
e
If you are operating your cooling device on board a boat with
a mains connection of 230 V from the land, you must install
a residual current circuit breaker between the 230 V mains
supply and the cooling device.
Seek advice from a trained technician.
➤ To operate the cooling unit from the 230 V mains, use the WAECO
rectifier
– EPS-100W for devices with Bd-35F compressor (50/80/CS series),
– MPS-35 for devices with Bd-35F compressor (50/80/CS series),
– MPS-50 for devices with Bd-50F compressor (90 series).
Note
I
The output voltage of the described rectifier is 24 V. Please
remember this when connecting other consumers at a later time.
7 Using the cooling unit
7.1

Energy saving tips

Choose a well ventilated installation location which is protected from
direct sunlight.
Allow hot food to cool down first before placing it in the device.
Do not open the refrigerated container more often than necessary.
Do not leave the door open for longer than necessary.
Defrost the refrigerated container once a layer of ice forms.
Avoid unnecessary low temperatures.
Clean the condenser of dust and dirt at regular intervals.
Clean the lid seal regularly.
46
ColdMachine