Connecting The Cooler; Using The Cooler - Dometic CDF2 36 Instrucciones De Uso

CDF236
6.4

Connecting the cooler

!
WARNING!
• Connect the device with the supplied DC cable only.
• Do not modify the DC cable. Modifying the DC cable may cause
safety risks.
• The DC cable must always be protected by 8 A fuse.
A
NOTICE! Danger of damaging the device
Disconnect the cooler and other consumer units from the battery before
you connect the battery to a quick charging device.
Overvoltage can damage the electronics of the device.
➤ Proceed as shown (fig. 5, page 4).
6.5

Using the cooler

A
NOTICE! Danger of overheating
Ensure at all times that there is sufficient ventilation so that the heat that
generated during operation can dissipate. Ensure that the ventilation
slots are not covered. Make sure that the device is sufficiently far away
from walls and other objects so that the air can circulate.
A
NOTICE! Danger from excessively low temperature
Ensure that the only those objects are placed in the cooler that are
intended to be cooled at the selected temperature.
• Locking the cooler: fig. 6 1, page 5
• Switching on the cooler: fig. 7, page 5
• Switching off the cooler: fig. 8, page 6
6.6 Fixing the cooler while transporting
When transporting the cooler in a vehicle, you can fix the device with the safety seat
belt or with luggage tighteners so that it remains in its position.
!
WARNING!
Make sure that the cooler is fixed correctly. Otherwise it could be dis-
lodged and cause severe injuries to passengers when a hard break
occurs.
EN
Operation
19