Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
BASIC GUIDELINES
FOR OPERATION
t.
Open the door and load your dishes (see page 15).
Remove any food remains from the dishes before placing them in the rack(s).
Place dishes into the upper and lower racks.
After placing the dishes into the racks, rotate the nozzles by hand to check whether
any of the
dishes will interfere with them.
Make sure the dishes will not prevent the detergent
dispenser
from opening.
2.
Add detergent
to the dispenser
(see page 17).
Make sure to use only automatic
dishwasher
detergent.
Refer to "Using
the dispenser"
on how to add detergent.
3.
Close the door, and then press the POWER
button.
When you press the POWER
button, the entire display turns on and off, and then the cycle light of
the most recently finished
cycle lights up.
If "Low
Rinse"
is illuminated,
you should
refill the rinse aid dispenser
to improve washing
and drying
performance.
4.
Select an appropriate
cleaning
cycle depending
on the soil level of the dishes (see pages 9
and 21).
Press the appropriate
cycle button.
When you press a cycle button, the cycle indicator
light is illuminated.
If you press the cycle button
again, the light turns off and the cycle is canceled.
For information
about selecting
a cycle according
to the soil level of the dishes, see "Cycle
selector"
on page 9.
5.
Press the START
button.
After you close the door and press the START
button
or you press the START
button
and close the
door, the dishwasher
starts the selected
cycle after a few seconds.
6.
When the wash cycle is completed.
The "End"
light illuminates
and the dishwasher
sounds
a chime.
The power
is automatically
turned
off after 10 minutes.
,/_
If you want to load more dishes or pause the dishwasher
while it is already running,
make sure to open
......._ the door slowly and carefully as there is a possibility
of injury from the hot steam inside the dishwasher.
(If the door is opened while the dishwasher
is running, a safety mechanism
is activated
and stops the
cycle.)
You should
use rinse aids for better drying performance.
You can further
improve drying performance
by also selecting
the Sanitize
option.
If the "Low
Rinse"
lamp lights during a cycle, the dishwasher
adds 30 more minutes to the Drying
cycle automatically
after the "End" light illuminates.
When the water temperature
of the last rinse of the sanitize option reaches the sanitary temperature
(over 155 °F (68 °C)), the "Sanitize"
lamp blinks, and then remains illuminated
until the Sanitize
option
ends. When you open the door or press the POWER
button, the "Sanitize"
lamp turns off.
English o 11
Publicidad
Tabla de contenido
