Audio-Technica ATH-ANC3 QuietPoint Manual De Instrucciones página 2

Ocultar thumbs Ver también para ATH-ANC3 QuietPoint:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

2
Warnings
Warnings
Please read these warnings before using your headphones. To ensure
safety, observe all warnings while using this equipment.
• Do not disassemble or attempt to repair headphones.
• Never use the headphones in places where the inability to hear ambient
sounds presents a serious risk (such as while operating a motor vehicle
or bicycle, or at railroad crossings, train stations, construction sites or
on roads or where vehicles and bicycles are traveling).
• Noise-cancelling headphones make it hard to hear outside low-pitched
sounds. Take care to recognize warning beeps and other auditory
reminders; be aware that the familiar sound of these alerts may be
changed by the headphones.
• To prevent damage to your eardrums, never use the headphones at
excessive volume levels. Listening to loud sounds for an extended
period may cause temporary or permanent hearing loss.
• Do not store the headphones in direct sunlight, near heating devices
or in hot, humid or dusty places.
• Do not subject the headphones to strong impact.
• Do not allow the headphones to become wet.
Battery precautions
• Keep batteries out of the reach of children.
• Use only disposable AAA alkaline batteries.
• Do not use rechargeable batteries.
• Observe correct polarity as marked.
• Remove depleted battery immediately.
• Please dispose of used batteries properly.
• Do not use a leaking battery. If battery leakage occurs, avoid contact
with skin. If contact occurs, immediately wash thoroughly with soap
and water. If battery leakage comes into contact with your eyes,
immediately flush with water and seek medical attention.
• Do not expose the battery to excessive heat.
ATH-ANC3 QuietPoint
headphones use an innovative active noise cancellation
technology developed by Wolfson Microelectronics plc
This technology effectively blocks outside noise, while offering high-fidelity
audio that is not diminished by the noise cancelling electronics.
Compliance with FCC rules (USA only)
This device complies with Part 15 of the FCC rules. Operation is subject
to the following two conditions:(1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC WARNING
You are cautioned that any changes or modifications not expressly
approved in this manual could void your authority to operate this equipment.
NOTICE
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be deter-
mined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
Canada only
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme á la norme NMB -003
du Canada.
This product conforms to the EMC Directive 89/336/EEC.
The complete declaration of conformity can be obtained
from Audio-Technica Limited, Royal London Industrial Estate,
Beeston, Leeds, UK, LS11 8AG.
English

Publicidad

Tabla de contenido
loading

Tabla de contenido