Replacing The Sharpening Stone; Cleaning The Saw; Battery Pack; Charger - Oregon СS250 Manual De Instrucciones

MAINTENANCE AND CLEANING
REPLACING THE
SHARPENING STONE
CAUTION: REPLACE
POWERSHARP® SAW CHAIN AND
THE SHARPENING STONE AT THE
SAME TIME. FAILURE TO DO SO
COULD RESULT IN DECREASED
PERFORMANCE OR DAMAGE TO
THE CHAIN AND/OR SHARPENING
STONE.
IMPORTANT: THE POWERSHARP®
INTEGRATED SHARPENING
SYSTEM IS FOR USE ONLY WITH
POWERSHARP® CHAIN.
With the chain saw off and cool and the
battery pack removed, remove the side
cover by removing the side cover knob
Install the new sharpening stone as
follows:
• Remove the two screws holding the
sharpening stone Remove the stone
(Fig 31)
• Make sure the PowerSharp® lever and
surrounding area are free of debris
• Place the new stone in place Replace
the screws and tighten snugly
• Reinstall side cover and tighten the side
cover knob
FIG. 31
28
OREGON® CORDLESS TOOL SYSTEM
CHAIN SAW MODEL CS250

CLEANING THE SAW

CAUTION: WHEN CLEANING
THE CHAIN SAW POWER HEAD, DO
NOT IMMERSE IN WATER OR OTHER
LIQUIDS.
• Remove battery pack before cleaning
• Remove wood chips and other debris
from the battery port Make sure the
contacts are clean and dry
• After use, clean debris from the chain
and guide bar Wipe power head with a
clean cloth moistened with a mild soap
solution Never use harsh cleaners or
solvents
• Always clean out wood chips, saw dust,
and dirt from the bar groove when
replacing the saw chain

BATTERY PACK

WARNING: THERE ARE NO
USER SERVICEABLE PARTS INSIDE
THE BATTERY PACK. DO NOT
DISASSEMBLE.
Lithium ion batteries have a
predetermined operating life If the
amount of cutting time per charge
decreases noticeably, the battery pack is
at the end of its useful life and should be
replaced
• Make sure the battery pack, including
the contacts, is clean, dry, and has no
signs of puncture, impact, or other
damage Broken batteries can cause
fires or emit hazardous chemicals
• Clean dirty contacts with a soft, dry
cloth Dirt or oil can cause a poor
electrical connection, resulting in loss of
power

CHARGER

• Unplug the charger from the electrical
outlet
• Clean dirty contacts with a soft, dry
cloth
AD 0213 - F/N 551309