Peg-Perego Viaggio 2-3 Flex Instrucciones De Uso página 25

(fig_b).
8• Viaggio2-3 Flex is fitted with two
lateral and removable cup holders.
How to attach the car seat
to the vehicle
if you own a car with
Isofix attachments
This type of attachment can be
used if your car is fitted with Isofix
hooks. Otherwise, go to the next
section. For further information on
the availability of these hooks and
their location, refer to the vehicle's
instruction manual.
Fastening the
guarantees greater stability and
safety in the vehicle, but cannot
replace the restraining function
of the vehicle's seat belts.
9• To bring out the attachments
located inside the Surefix Base, pull
the handle on the bottom front part
of the seat longitudinally towards
you (fig_a). The attachments will be
automatically ejected (fig_b). Repeat
to make sure the attachments
have been ejected
simultaneously.
10• Fix the attachments to the Isofix
hooks on the vehicle seat, ensuring
they "click" into place.
11• After fixing the attachments, pull
the front handle again (fig_a) and, at the
same time, push the car seat towards
the vehicle' s seat (fig_b), then release
the handle.
12• IMPORTANT: The vehicle's
Isofix hooks and the car seat's Surefix
Base attachments are correct coupled
when a green signal appears above
the connectors (fig_a). A red signal
indicates that the attachments have
NOT been coupled correctly (fig_b) .
13• To release Viaggio 2-3 Flex from
the vehicle seat, pull the handle (1)
until the Surefix Base attachments are
fully revealed. In so doing, the yellow
release buttons will be visible on the
sides of the base; pull the two buttons
(2) until you hear the attachments click
open. At this point you can remove
the car seat.
14• To reposition the attachments
inside the Surefix Base (when not in
attachments
use), pull the lever once more (1) and
simultaneously push one of the two
attachments in (2) until they practically
disappear
How to attach the car seat
to the vehicle
if you own a car with no
Isofix attachments
15• Position the Viaggio 2-3 Flex
fully and car seat on the vehicle seat in the
direction of travel, leaving the
attachments inside the Surefix Base
(fig_a) and position the child in the
seat as shown in the figure (fig_b),
ensuring the car seat does not move
during this operation.
How to secure your child
with Viaggio 2-3 Flex
18