Charging The Battery - Hilti SF 6-A22 Manual De Instrucciones Original

5.3

Charging the battery

1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery.
5.4 Installing the side handle
CAUTION
Risk of injury! Loss of control over the rotary hammer drill.
▶ Check that the side handle is fitted correctly and tightened securely. Make sure that the clamps are
correctly seated in the grooves provided for the purpose.
1. Move the forward/reverse switch into the middle position.
2. Turn the grip to release the clamps of the side handle.
3. Seat the side handle clamping band fully on the housing and push the clamps into the grooves provided
for the purpose.
4. Turn the grip to tension the clamps of the side handle.
5.5 Fitting the belt hook (optional)
WARNING
Risk of injury. A falling power tool may present a risk of injury to yourself and others.
▶ Check that the belt hook is fitted securely before beginning work.
The belt hook allows the power tool to be attached to a belt worn by the operator. The belt hook can
be fitted to allow attachment on the left or right side of the body.
1. Remove the battery. → page 19
2. Insert the belt hook into the opening provided at the base of the product.
3. Secure the belt hook with the two screws.
4. Insert the battery. → page 19
5.6 Installing Hilti bit holder (optional)
1. Remove the battery. → page 19
2. Insert the bit holder into either the left or right opening provided at the base of the product.
3. Secure the bit holder with the two screws.
4. Insert the battery. → page 19
5.7 Hilti Installing the retaining strap (optional)
ATTENTION
Damage to the product and / or the lanyard. Incorrect handling can result in damage to the product and/or
lanyard.
▶ Do not use a metal chain as a lanyard. Do not use lanyards longer than 2,0 m (6 ft).
To avoid damage and injury, when working at a height it is advisable to use the Hilti retaining strap.
The retaining strap allows a securing cord or lanyard to be attached.
When working with the product, you must comply with national regulations for working at heights.
1. Remove the battery. → page 19
2. Insert the two tabs on the retaining strap into the slots on each side of the base.
3. Secure the retaining strap with the screws supplied.
4. Insert the battery. → page 19
20 English
Printed: 19.08.2019 | Doc-Nr: PUB / 5467412 / 000 / 01
2
3
4
5
2231426
*2231426*