Manufacturer's Warranty - Hilti SF 6-A22 Manual De Instrucciones Original

Trouble or fault
1 LED flashes.
The drill / driver does not
work.
SF 6H-A22
Hammer-action drilling is not
possible.
The control switch cannot be
pressed, or is stuck.
The drill / driver or the battery
gets very hot.
9 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
Battery disposal
Improper disposal of batteries can result in health hazards from leaking gases or fluids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
10 RoHS (Restriction of Hazardous Substances)
Click on the links to go to the table of hazardous substances:
• SF 6-A22: qr.hilti.com/r9370541
• SF 6H-A22: qr.hilti.com/r9370482
There is a link to the RoHS table, in the form of a QR code, at the end of this document.
11

Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
*2231426*
Printed: 19.08.2019 | Doc-Nr: PUB / 5467412 / 000 / 01
Possible cause
The battery is discharged.
The battery is too cold.
The battery is too hot.
The operating mode is not set cor-
rectly at the selector ring.
The forward/reverse selector
switch is in the middle position
(transport position).
Electrical fault
The drill / driver is overloaded (ap-
plication limit exceeded).
2231426
Action to be taken
▶ Change the battery and charge
the empty battery.
▶ Bring the battery to the recom-
mended working temperature.
▶ Bring the battery to the recom-
mended working temperature.
▶ Set the selector ring to the
"Hammer-action drilling" posi-
tion .
▶ Set the forward/reverse selector
switch to forward or reverse ro-
tation, as applicable. → page 21
▶ Switch the drill / driver off
immediately, remove the battery
and contact Hilti Service.
▶ Check the application.
English 23