Sperian Miller DURAHOIST Serie Instrucciones De Uso página 20

6.3 Installation of DH-12 Vehicle Hitch
Mount Sleeve & Accessories
6.3.5 Mounting the DH-16 2" Ball Hitch Adapter to the DH-12
Vehicle Hitch Mount Sleeve
1
Align bottom portion of DH-16 with
the last hole set on the DH-12.
2
Apply washer to bolt, insert bolt
and apply second washer. Then
secure nut with a snug fi t (approx.
20 ft-lbs.).
3
Secure upper portion of the DH-16
to the DH-12 by inserting both
bolts (add a washer to both ends
of the bolts).
4
Apply nut to both bolts and tighten
to a snug fi t (approx. 20 ft-lbs.).
5
Slip DH-16 over DH-12 post and
insert pin to secure position,
making sure DH-12 is level with
ground.
6
Lay DH-16 over hitch receiver and
lock into position by pushing lever
down.
7
Lift bottom half DH-16 and secure
by inserting pin into hole set near
the bolt you applied in step 2.
8
Tighten adjuster screw on bottom
portion of DH-16.
9
Insert mast and tighten tri- screw
as needed.
USE R I N S TR U C TIO N S - E N G L I SH
The 2" Ball Hitch Adapter installs between the DH-12 and the attendant
vehicle and mates with all standard 2" ball hitches.
1
2
3
4
5
20
6
7
8 8 8
9
Complete Installation