Waring Commercial WDM360 Manual Del Operador página 4

The drink mixer can be operated without engaging the ON/OFF
cup actuator by using the PULSE
switch will operate at whatever speed the 3-speed switch is set to.
The PULSE
backwards. Keep a firm grip on the cup while using PULSE
Your Waring
®
and 3 "butterfly" (with the movable flaps). To switch agitators,
simply hold the spindle shaft with one hand and turn the agitator
in a clockwise direction. This will loosen the screw, and you
can unscrew to remove. Insert replacement agitator and screw
bottom screw back in. Tighten by turning the agitator in a
counterclockwise direction. Use only standard metal mixing cups
with the drink mixer.
CLEANING & SANITIZING INSTRUCTIONS
1. Rinse container thoroughly under running water. Add 8
ounces of clean rinse water to container. Place container in
normal operating position on mixer and run on high speed
for two (2) minutes. Empty container. Repeat process for all
spindles.
2. UNPLUG MIXER POWER CORD FROM ELECTRICAL
OUTLET.
3. To remove bottom cup supports (C), simply push each
support up, then pull out.
4. To remove the upper cup holders (D), hold the notches on
both sides of the holder, then pull directly out from the base.
5. Wash, rinse, and sanitize the container supports, upper
cup holder and container. Sanitize these parts by immersing
in sanitizing solution for two (2) minutes. Shake off excess
moisture and allow parts to air dry.
switch will only operate while pressed forward or
Drink Mixer is supplied with 6 agitators, 3 standard
toggle switch. The Pulse
4
.