Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
REMOVING
THE REFRIGERATOR
DOORS
For some installations you need to remove the
fridge and freezer drawers so you can move the
refrigerator to its final location.
Do not remove the doors/drawer
if you don't need
to. If you do not need to remove the refrigerator
doors, go to Adjusting the Level on page 15.
If you need to remove the doors, continue below.
Before removing the door/drawer, make sure you
read the following items:
z_ WARNING
Disconnect power to the refrigerator before
removing the doors or drawers.
Be careful not to drop, damage or
scratch the doors/drawers
while
removing them.
Use care when you remove the doors/drawers.
The doors are heavy and you could injure
yourself.
Reattach the doors/drawers
properly to avoid:
Moisture from air leakage.
Uneven door alignment.
Wasting energy due to improper door seal.
Disassembling
the refrigerator
doors
z_ WARNING
Be careful not to drop and scratch the doors while
removing them.
With
the door
opened
1. Remove 3 screws holding down the TOP
TABLE ( 1 ) and separate the connected wires.
_
(1)
Disconnect two connectors ( 2 ) on the left side
door. To remove the water coupler from the
hinge, twist and pull it from the hinge.
Remove the water line ( 3 ) while pressing the
marked part ( 4 ) of the water line coupler.
(2) --
(3)
/_ CAUTION
If a red clip is on the coupler, you must remove it
before removing the tube.
Pull and remove the hinge lever ( 5 ). Remove
the ground screw ( 6 ) attached to the upper
left door hinges with a philips screwdriver (+).
Remove the upper left and right door hinges
(7).
_
(6) /
(7)--__
iiiiiiiiiiiiiiii
iiiiiiiiiiiiiiii
Engl sh - 11
Publicidad
Tabla de contenido
