Making Ice - Samsung RF3OHB Serie Manual Del Usuario

USING THE COLD WATER AND
iCE DISPENSERS
Push the appropriate button to select
what you want dispensed.
Water Cubed Crushed IceOff
NO ICE
Using the ice lever ( 1 )
Place a glass underneath the
ice dispenser and push gently
against the dispenser lever with
your glass.
Make sure the glass is in line with
the dispenser to prevent the ice
from bouncing out.
(2)_
Using the Water lever ( 2 )
Push the Water lever dispenser ( 2 ) gently with
your glass. Water will be released from the
dispenser.
If you push the water and Ice lever at
about the same time, the dispenser
operates only the option you actually
selected or pushed first.
Please wait 1 second before removing
the cup after dispensing water to prevent
spills. Do not pull out the lever dispenser
after dispensing ice or water. It comes
back automatically.
Using the Ice & Water Dispenser together
To get Ice and water, push the Ice lever ( 1 ) first
for ice, then move your glass down and press the
water dispenser lever (2 ) for water.
Maintaining the Ice Bucket
+ To clean the ice bin/bucket, wash with a mild
detergent, rinse well, and dry thoroughly it. Do
not use harsh or abrasive cleaners or solvents.
+ Ice is made in cubes. When you select
"Crushed", the ice maker grinds the ice cubes
into crushed ice.
+ When you select Cubed Ice after using the
Crushed Ice mode, a small amount of residual
crushed ice might be produced.
+ The ice cubes generated by the rapid ice
making process will look white, which indicates
they were generated normally.
+ If you need a large amount of ice and the ice
maker is making ice cubes quickly, move ice
cubes from the refrigerator ice bin to the freezer
ice bin to open up space in the refrigerator ice
bin. The ice maker will then make additional ice.
+ If ice doesn't come out, pull out the ice bucket
and press the test button located on the right
side of ice maker. See the illustration below.
+ Do not press the test button continuously when
the tray is filled with ice or water. Water may
overflow or ice may jam the bucket.
Making Ice
+ To fill the ice bucket to maximum capacity after
installation, follow these steps:
1. Allow your refrigerator to operate and cool
down for 24 hours (or 1 full day).
Waiting 24 hours will allow your ice maker to
cool properly.
2. Dispense 4 to 6 ice cubes into the glass.
3. After 8, and then 16 hours, dispense a full glass
of ice.
+ To test the ice maker, press the Test button
on the ice maker. You will hear the refrigerator
chime (ding-dong). When the chime sounds,
release the Test button.
+ The chime sounds automatically again to let
you know the ice maker is working well.
Eng+sh- 25