Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
/K CAUTION
Both control levers must be touching the floor
to prevent the refrigerator from tipping over and
causing personal injury or property damage.
1"
z_ CAUTION
If the refrigerator is installed on an uneven floor, it
may tilt. To prevent this, adjust the control levers
on both front legs so that they contact the floor
firmly.
®
®
If the right side is lower, perform the same
procedure, but with the right control lever.
It is difficult to remove the cover leg
front from the refrigerator, so we do not
recommend making small adjustments
with the control lever.
Instead, refer to the next page for the best
way to make minor adjustments to the
doors.
MAKING
MINOR ADJUSTMENTS
TO THE DOORS
A leveled refrigerator is necessary for getting the
doors perfectly even.
For leveling instructions, review the previous
section on leveling the refrigerator.
The left door is fixed.
To make minor adjustments between
doors, adjust only the right door.
1. Pull out the freezer drawer ( 1 ) to reveal the
lower hinge ( 2 ).
2. Insert the supplied allen wrench (5/32" (4 mm))
( 3 ) into the shaft ( 4 ) of the lower hinge.
3. Adjust the height by turning the hex wrench
( 3 ) clockwise (
....
) or counter clockwise
.....
(3)
(3)
7
....
When you turn the hex wrench counter-
clockwise (
), the door will move up.
MAKING
MINOR
ADJUSTMENTS
BETWEEN
OUT DOOR AND IN
DOOR
After raising the out door, insert the supplied SHIM
HINGE MIDDLE in the gap between the OUT
DOOR and the HINGE-SHAFT.
i:
I
"-[rl_' f ................
SHIM HINGE MIDDLE are enclosed with
the refrigerator.
The thickness of RING is 0.04" (1 mm).
/K CAUTION
Keep the Rings out of the reach of children and
make sure that children do not play with them or
put them into their mouths.
Engl sh - 16
Publicidad
Tabla de contenido
