Sears Kenmore 67272 Manual Del Propietário página 18

Problem Solution
Water droplets form on inside of • It is normal during high humidily periods or if doors have been opened
refrigerator' frequently,,
• Wrap food tightly and wipe off damp containers prior to storing in the
refrigerator to avoid moisture accumulation.
water droplets form On 0uisicle Of , Check do0r"seals fo; proper seal Gaskets shoul'd'seal tightly io....................................
refrigerator cabinet
• It is normal during high humidity periods or if doors have been opened
frequently
Temperature controlled meat drawer ° Check for a package that may prevent drawer from closing properly
or crisper drawer does not close ° Confirm drawer is in proper position
freely (some models) ° Clean drawer channels with warm, soapy water Rinse and dry
thoroughly.
- Apply a thin layer of petroleum jelly to drawer channels
• Confirm refrigerator is level.
Refrigerator has an Od0rl • See "Odor Removal" instructions in "Care and Cleaning" section.
Refrigerator makes unfamiliar sounds • It may be normal. See "Normal Operating Sounds" section.
or seems too loud.
Ice cubes have an odor ,, See "Odor Removal" instructions in "Care and Cleaning" section
Ice cubes stick together or "shrink"
Ice maker is not producing ice,
Ice maker is not producing enough
ice.
Ice forms in inte'i' t ube"io"ice"maker.
• Ice maker was recently installed, Discard first few batches of ice to
avoid discolored or off41avored ice
• Food has not been wrapped tightly in either refrigerator or freezer
compartment Rewrap foods since odors may migrate to the ice if food
is not wrapped properly
• Discard ice and clean ice bucket or trays more frequently Ice cubes
are porous and absorb odors easily
,_ Water supply contains minerals such as sulfur, In some situations a
filter may need to be installed to eliminate taste and odor prQb!ems:
• Empty ice cube bucket or trays more frequently° If used infrequently,
ice cubes me--ether or shrink.
• Water pressure may be to low or high Ice maker requires a water
pressure of 20q20 psi to function properly
• Confirm ice maker arm is down. See "Automatic Ice Maker" section.
• Confirm household water supply is reaching water valve Make sure
the water vaive shut off is fully turned on
o C0nfi_m ice maker wiring harness iS inserted comp!ete!y in proper
holes,
• Check for kinks in copper or plastic tubing. Remove kinks or replace
tubing.
• Check electrical connections to water valve coil and connector block
on refrigerator cabinet..
,, If a water filter has been installed on the water line outside the
refrigerator, check the filter for clogs or improper installation of the
filter.
• Ice maker has just recently been installed or a large amount of ice has
just been used, Wait 24 hours for ice production to begin and for ice
maker to restock after emptied
• Confirm household water supply is reaching water valve_ Make sure
the water valve shut off is fully turned on.
° Piercing type or _lt_"saddle valve was used for hookup. Both reduce
water flow and may become clogged with time. Replace these valves
with correct type of saddle valve requiring '/4" hole to be drilled in water
supply pipe prior to valve attachment
,, Check for kinks in copper or plastic tubing. Remove kinks or replace
tubing
• Confirm freezer section is operating at proper temperature. Freezer
.must be cold enough to produce ice. See 'Setting..Controls" section.
,m Check water pressure. Low water pressure causes valves to leak.
18