Makita LXDT01 Manual De Instrucciones página 6

Changing the hammering force
1
S H
2
S H
3
S H
4
011217
Hammering force grade
displayed on panel
Hard
S H
Medium
S H
Soft
S H
011268
The hammering force can be changed in three steps:
hard, medium and soft.
This allows a tightening suitable to the work.
Every time the hammering force button
number of blows changes in three steps.
For approximately one minute after releasing the switch
trigger, the hammering force can be changed.
NOTE:
When all lamps on the switch panel go out, the tool
•
is turned off to save the battery power. The hammer
force grade can be checked by pulling the switch
trigger to the extent that the tool does not operate.
During the operation of switch trigger, the hammer
•
force grade cannot be changed.
1. Changed in
three steps
2. Hard
3. Medium
S H
4. Soft
5. Hammering
force button
5
Maximum blows
3,400 /min.
2,800 /min.
1,300 /min.
is pressed, the
Application
Tightening when force
and speed are desired.
Tightening when a good
finishing is needed.
Tightening when excessive
tightening need to be avoided
because of potentially clogged
female screw and broken or
damaged screw head.
Empty signal for remaining
battery capacity
011220
Pulling the trigger switch when the remaining battery
capacity become very low makes LED indicator flicker.
If the tool is used continuously with the LED indicator
6
Work
Tightening in underwork
material/ Tightening long
screws/ Tightening bolts.
Tightening in the finishing
board, plaster board.
Tightening sash screw/
Tightening small screws
such as M6.
1. LED indicator
S H
1