Makita LXDT01 Manual De Instrucciones página 9

Troubleshooting
Trouble
The tool stops
during operation.
011187
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Screw bits
•
Hook
•
Plastic carrying case
•
Various type of Makita genuine batteries and
•
chargers
Light status/LED indicator status/tool status
LED indicator for empty signal for
remaining battery capacity lights up.
Light flickers once per second.
Light flickers five times per second.
Switch trigger has been pulled
continuously for more than 130 seconds.
Other Symptoms
or attachments
Only use accessory or
Remaining battery capacity level is low.
Charge the battery cartridge.
When the LED indicator still lights up
even after charging the battery cartridge,
the tool temperature is high.
Cool down it fully. The tool restarts after its
temperature becomes low.
When the status is still unchanged, stop
using and have the tool repaired by a
Makita local service center.
The tool temperature is high. Cool down
it fully. The tool restarts after its temperature
becomes low.
Use the tool with the motor not locked.
(When the tool has stopped due to the
motor locking, withdraw the battery
cartridge one time and then insert it again
or release the switch trigger for more than
60 seconds to restart the tool.)
If the motor still remains locked, stop using
and have the tool repaired by a Makita
local service center.
Release the switch trigger.
Stop using and have the tool repaired by
a Makita local service center.
are
9
Steps to be taken