Attaching The Handle - Craftsman 247.770120 Manual De Instrucciones

ATTACHING THE HANDLE
1, Removethe hairpinclipsfrom the handlebracketsand remove
the carriagescrewsand wingnuts from the lowerhandle,
a, Placethe bottomholesin lowerhandleoverthe pinson the
handlebracketsand securewith hairpinclips,See Figure2,
b, insert carriagescrewsthroughupperhole in lowerhandle
fromthe insideand securewith wing nuts,See Figure2,
2, a, Unfoldthe upperhandle untilit alignswith lowerhandle,
Makesure the ropeguide is on the rightsideof upperhandle,
See Figure3,
I_,IPORTANT: Makesure thecables are routedoutsidethe lower
handle,Also, do not crimpthe cables whilelifting up the handles,
b, Securethe two handlesbytighteningthestar knobs
(carriagebolts mustbe seated properlyintothe handle),See
Figure3,
3, Loosenthe wingnutthat securesthe rope guideto the rightside
of upperhandle,
a, Pull the starterropeout of the engineslowly,See Figure4,
b, S@the starterrope intothe rope guide,
c, Tighten thewing nut, See Figure4,
f
f
f
Figure2
Figure3
J
J
9
Figure4
J