Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WALL CUPS

Do not use this gate in any location without using all 4 wall cups,
sticky pads, and screws provided when installing the gate.
1.
Ensure that the wall cups are on the ends of the
adjustment rods. Hold the square wall cup on the
handle adjustment rod.
2. Temporarily place the gate where you want to
install it, flush with floor. Pull the adjustment rods
out until they reach the walls and trace the position
of each wall cup with a pencil.
3. Retract the adjustment rods and set the gate aside
for now.
4a. FOR DRYWALL WITHOUT STUD/PLASTERBOARD:
Hold the wall cups in position and mark the center
with a pencil. Then put the cup aside and drill a
7/32" hole into the drywall at the center mark.
Insert a drywall anchor.
4b. FOR DRYWALL WITH STUD: Hold the wall cups in
position and mark the center with a pencil. Then
put the cup aside and drill a 5/64" hole into the
drywall at the center mark.
How to Install
2
4a. Without Stud
7/32"
4b. Stud
5/64"
8

Publicidad

Tabla de contenido
loading

Tabla de contenido