Unpacking And Removing Shipping Bolts - LG WM3470H A Serie Manual De Propietario

Ocultar thumbs Ver también para WM3470H A Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Unpacking and removing shipping bolts

When removing the washer from the carton base, be sure to
remove the foam drum support in the middle of the carton
base.
If you must lay the washer down to remove the base
packaging materials, always lay it carefully on its side.
Do NOT lay the washer on its front or back.
INSTALLATION INSTRUCTIONS
1
Remove the bottom two shipping bolts with the wrench
(included) to fully loosen all four shipping bolts by turning
them counterclockwise and then pulling them out.
Shipping
bolt
2
Locate the four hole caps included in the accessory pack
and install them in the shipping bolt holes.
Cap
NOTE
Save the bolt assemblies for future use. To prevent
y
damage to internal components, DO NOT transport the
washer without reinstalling the shipping bolts.
Failure to remove shipping bolts and retainers may
y
cause severe vibration and noise, which can lead to
permanent damage to the washer. The cord is secured
to the back of the washer with a shipping bolt to help
prevent operation with shipping bolts in place.
13
Retainer

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Wm8000ha serie

Tabla de contenido