Adjus ng the energizer output voltage
a)
Press the setup bu on (
bu ons ( < or >) to highlight the quickscan bargraph display (it will start
fl ashing).
b)
Press (+ or -) to adjust the output voltage up or down. The output voltage can
be adjusted from 4.5KV to 8KV. The factory default se ng is 8KV.
c)
To exit the setup mode wait 10 seconds or press the setup bu on (
14
Gallagher 3E3084 M1800i M2800i 110v Energizer User Manual
) to enter setup mode and use the naviga on
Controller showing the output voltage being adjusted
).