Power Source; Led Display - Schumacher PID-410 Manual Del Usuario

6. POWER SOURCE

Your average automobile or marine battery at full charge will provide an ample power
supply to the inverter for approximately 3 hours when the engine is off. The actual
length of time the inverter will function depends on the age and condition of the battery
and the power demand being placed by the device being operated with the inverter.
If you decide to use the inverter while the engine is off, we recommend you turn
OFF the device plugged into the inverter before starting the engine. To maintain
battery power, start the engine every 2 to 3 hours and let it run for approximately
10 minutes to recharge the battery.
Although it is not necessary to disconnect the inverter when turning over the
engine, it may briefly cease to operate as the battery voltage decreases. While
the inverter draws very low amperage when not in use, it should be unplugged to
avoid battery drain.

7. LED DISPLAY

The LED display identifies the current status of the inverter.
VOLTS DC: The voltage of the vehicle's battery, Portable Power jump starter or
DC power source.
VOLTS AC: The voltage supplied to the device through the AC receptacle.
WATTS: The power or wattage supplied to the device plugged into the inverter.
An audio alarm will sound when any of the following codes display. To stop the
alarm, press the ON/OFF switch:
 – The inverter is not functional. See warranty and call Customer Service.
 – The vehicle's battery voltage is more than 15.5V. The inverter will
automatically restart after the voltage drops below 15.0V.
 – The continuous load demand from the device exceeds the inverter's
wattage output.
 – The inverter is overheated and automatically turns off for a period of 1 to
3 minutes to cool. Make sure the inverter is well ventilated. It will automatically
restart after it cools.
 – The vehicle's battery voltage is less than 10.5V.
 – Short circuit, power surge or overload in the device.
• 7 •