Hilti SID 4­A22 Manual De Instrucciones Original página 33

Observe the safety instructions and warnings in this documentation and on
the product.
6.1 Setting the torque
▶ Push the torque selector button repeatedly until the desired torque setting
is displayed in the torque display.
6.2 Setting forward or reverse rotation
▶ Set the forward/reverse switch to the desired direction of rotation.
➥ The control switch is locked when the forward/reverse switch is in the
middle position (safety lock). An interlock prevents switching while the
motor is running.
6.3 Switching on
▶ Press the control switch.
➥ Speed of rotation is regulated by the distance the control switch is
pressed in.
6.4 Screwdriving
CAUTION
Risk of injury by damaged workpieces! Screws or workpiece can be
damaged if torque is too high. This presents a risk of injury.
▶ Make sure that screws and workpiece are suitable for the torque produced
by the tool.
1. Move the forward/reverse switch into the middle position.
2. Use the torque selector button to set the desired torque. → page 27
3. Set the forward/reverse switch to the desired direction of rotation.
6.5 Switching off
▶ Release the control switch.
6.6 Removing the accessory tool
CAUTION
Risk of injury by the accessory tool! The accessory tool might be hot or
have sharp edges.
▶ Wear protective gloves when using the power tool and when changing
accessory tools.
1. Set the forward/reverse switch to the middle position or remove the
battery from the power tool.
2. Pull the chuck ring forward and hold it in this position.
3. Pull the accessory tool out of the chuck.
4. Release the chuck ring.
*2145524*
Printed: 14.10.2019 | Doc-Nr: PUB / 5293888 / 000 / 06
5
4
2145524
6
English 27