maintenance
• Some parts might stain when in contact with certain fruits and vegetables. In order to
avoid this, all parts should be washed immediately after each use.
problems and solutions
PROBLEM
Juice Extractor will not work
after switching on.
Motor makes loud noise and unit
starts vibrating.
Motor appears to stall while
juicing.
Too much pulp builds up on
stainless steel filter.
Pulp is too wet with less juice
extraction.
Juice leaks between the rim of
the Juicer and Cover
Motor stops after continued
heavy use.
SOLUTION
• Lid/Cover might not be locked into position.
• Turn off and unplug unit then ensure all parts are
assembled properly.
• Turn off and unplug unit then check if there are any
residues blocking the unit.
• Turn off and unplug unit then ensure all parts are
assembled properly.
• Juicing overripe fruits may produce too much pulp
and clog the filter. Turn off and unplug unit then
clean the filter thoroughly.
• If pulp starts building up under the lid, slow down
the juicing process.Turn off and unplug unit then
clean the filter basket, stainless steel filter and lid.
• Follow the instructions to disassemble
the unit included in the "After Using Your
Juice Extractor" section. Clean out the pulp
from the filter.
• Try reducing the speed or slowing the juicing action.
Remove stainless steel mesh filter and thoroughly
clean mesh with the nylon brush. Rinse the filter
basket with hot water . If the fine mesh holes are
blocked, soak the basket in a solution of hot water
with 1 0% lemon juice to unblock the holes or
wash in the dishwasher . This will remove excess
fibre build up (from fruits or vegetables), which could
be reducing the flow of juice.
• Try reducing the speed or slowing the juicing action
by pushing the Food Pusher down slower.
• The motor contains a resettable fuse to protect
against overheating. Turn the juice extractor off
"
" and unplug it from the electrical outlet.
After the juice extractor has cooled, plug the juice
extractor into the electrical outlet and resume
normal use.
9