Overload Indication - Domo DO9088W Manual De Instrucciones

DO9088W
BATTERY
1 pc lithium battery. Please remove the isolation sheet from the battery contact before
use. Please take note to the polarity.
TO REPLACE THE BATTERY
Open the battery case cover on the back of the scale.
Bend the small black tab outwards and the battery will come out. Take note not to
bend the contact. Install the new battery by putting one side of the battery beneath the
contact and then pressing down the other side.
OPERATION
1. Put the scale on a hard and flat surface (avoid carpet or soft surfaces).
2. Gently step on the scale. It will switch on automatically. Put your feet evenly on
the scale, stand still and wait until the weight on the display is stable and locked.
AUTOMATIC SWITCH-OFF
When you step off the scale, it will automatically switch off. after +/- 8 seconds.

OVERLOAD INDICATION

"Err" code indicates scale overload.
LOW BATTERY INDICATION
"Lo" code is shown when the battery power is low. Please install a new battery.
ERROR DURING WEIGHING
"C" code is shown when an error occurs during weighing. Step back on the scale to
weigh again.
ADVISE FOR USE AND CARE
• Keep standing still during the course of weighing.
• Attention: the glass surface can be slippery when wet. Keep the surface dry.
• Do not strike, shock or drop the scale.
• Treat the scale with care as it is a precision instrument.
• Clean the scale with a damp cloth and avoid water getting inside the scale.
• Do not use chemical or abrasive cleaners.
• Keep the scale in a cool place with dry air.
• Always keep your scale in a horizontal position.
• If the scale does not switch on, check whether the battery is installed or the
battery power is low. Insert a new battery.
• If there is an error on the display or if you can not turn off the scale for a long
time, please take out the battery for a short time, then install it again. If you
cannot resolve the problem, please contact your dealer.
• Do not use for commercial purposes.
18