ENGLISH
To prevent any accidents:
• This toaster complies with the safety rules and conditions in effect, and
with the following directives
- Electromagnetic Compatibility Directive 89/336/CEE modified by
Directives 92/31/CEE and 93/68/CEE.
- Low Voltage Directive 73/23/CEE modified by Directive 93/68/CEE.
• Check that the electricity supply voltage corresponds to the voltage
indicated on the appliance (ac current only).
• Given the many standards in effect, if this toaster is used in a country
other than the country where it was purchased, have it checked by an
approved service centre (see enclosed after sales service information).
• Check that the electricity installation is sufficient to supply the power
required by this appliance.
• Always plug the toaster into an earthed socket.
• Do not let the cord hang over the edge of countertop or come in contact
with hot surfaces.
• Do not store the cord or the plug between the slots in the appliance.
• Do not disconnect the appliance by pulling on the cord.
• Use extension cords which are in good condition, with an earthed
connection, and with a minimum rating of 10A.
• In order to avoid electric shock, do not immerse the cord, the plug or
the toaster in water or any other liquid.
• Do not use metal utensils in the toasting mechanism, which could cause
short circuits or electric shock (spoon, knife...).
• Use a stable work surface, away from any contact with water and never
in a built-in kitchen alcove.
• Do not move or carry the appliance when operating it.
When using electrical appliances, basic safety precautions should always be followed:
DO:
• Carefully read and follow all the instructions of use.
• Close supervision is necessary when the toaster is used by or near children.
• The toaster must always be used in the upright position, never on its
side or tilted forwards or backwards.
• Before each use make sure that the crumb tray is in its proper location.
• Regularly remove crumbs from the crumb tray.
• The bread control lever must be in the "Up" position before plugging in
or unplugging the appliance.
• Unplug the appliance if it shows any working abnormalities.
• Unplug from the power socket when not in use and before cleaning.
Allow to cool down before cleaning or storing it.
• To disconnect remove the plug from the wall socket (when the toasting
cycle is finished).
• If the bread jams in the slots after toasting and the elements do not
switch off, disconnect the plug immediately and wait for the appliance
to cool down before attempting to remove the bread.
Safety instructions
IMPORTANT SAFEGUARDS