Care And Maintenance; Cleaning The Body - Bodum BISTRO 11520 Instrucciones De Uso

Batidora eléctrica de mano
Ocultar thumbs Ver también para BISTRO 11520:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 30
– Before connecting the hand mixer to the mains, check
that the speed control (1) is set to position «0».
USING THE MIXER
IMPORTANT: to prevent overheating of the motor, switch
off the mixer after four minutes continuous operation and
wait two minutes before continuing.
– Place the ingredients in a bowl. Ensure that the accesso-
ries do not touch the base or sides of bowls made of glass
or porcelain.
– Immerse the accessories in the mixture and select the
appropriate speed setting (1). See the SPEED SETTINGS
section.
– To avoid splashing, keep the accessories immersed in the
mixture while mixing.
– When you have finished mixing, set the speed control (1)
to «0» and disconnect the mixer from the mains.
– When you have finished using the mixer, place it on the
rest (9) with its four non–slip silicon feet.
REMOVING THE ACCESSORIES
– Before removing the accessories, set the speed control (1)
to «0» and disconnect the mixer from the mains.
– Press the accessory release button (2) to release the acces-
sories. Hold the accessories by the shaft when doing so.
– Note: to safeguard your safety, the accessories can be
released only if the speed control (1) is set to «0».
STOWING THE CORD
– The cord should be stowed back in the cord compartment
(6) when you have finished using the mixer.
– Swing out the crank (7).
– Using one hand to hold the mixer by its handle (11), use
the other hand to turn the crank (7) until the cord is
stowed back in the cord compartment (6).

CARE AND MAINTENANCE

– Disconnect the hand mixer from the mains before cleaning it.
– Do not use abrasive cleaners.
CLEANING THE ACCESSORIES
– Remove surplus mixture from the accessories using a
rubber or plastic spatula.
– The accessories can be washed by hand; they are also dish-
washer proof.
– Any other servicing should be performed by an autho–
rized servicing representative.

CLEANING THE BODY

– Use a damp cloth only to clean the exterior surfaces of the mixer.
– Never immerse the motor unit, mains plug or cord in
water: remember that this is an electrical appliance.
6

Publicidad

Tabla de contenido
loading

Tabla de contenido