Standard Accessories - Hitachi C 6MEY Instrucciones De Manejo

C6MEY: Circular Saw
Read all safety warnings and all instructions.
Always wear eye protection.
Always wear hearing protection.
Only for EU countries
Do not dispose of electric tools together with
household waste material!
In observance of European Directive 2002/96/
EC on waste electrical and electronic equipment
and its implementation in accordance with
national law, electric tools that have reached
the end of their life must be collected separately
and returned to an environmentally compatible
recycling facility.
V Rated voltage
n
No-load speed
0
Switching ON
Switching OFF
Disconnect mains plug from electrical outlet
Mode selector switch
Lighting switch
Prohibited action
Class II tool

STANDARD ACCESSORIES

In addition to the main unit (1 unit), the package contains the
accessories listed on page 149.
Standard accessories are subject to change without notice.
APPLICATIONS
Cutting various types of wood.
SPECIFICATIONS
Model
Voltage
Power Input
No-Load Speed
Cutting
Capacity
depth
Weight*
C6MEY
230 V
1050 W
4100 min (Power mode)
-1
2500 min (Silent mode)
-1
90° 66 mm
45° 45 mm
2.8 kg
* According to EPTA-Procedure 01/2003
NOTE
Due to HITACHI's continuing program of research and
development, the specifi cations herein are subject to
change without prior notice.
Electronic control
○ Soft-start
○ Overload protection
This protection feature cuts off the power to the motor
in the event of overloading of motor or a conspicuous
reduction in rotational speed during operation.
When the overload protection feature has been
activated, the motor may stop.
In this case, release the tool switch and eliminate causes
of overloading.
After that you can use it again.
○ Overheat protection
This protection feature cuts off the power to the motor
and stops the power tool in the event of overheating of
motor during operation.
When the overheat protection feature has been
activated, the motor may stop.
In this case, release the tool switch and cool it down in a
few minutes.
After that you can use it again.
○ Rotation speed changeover function (Power mode /
Silent mode)
(Power mode / Silent mode switch function)
Each press of the Mode Selector Switch changes the
operating mode. (Fig. 15)
Silent mode reduces maximum motor RPM enabling
effi cient work with less noise.
The Silent Mode Indicator Lamp lights in Silent mode.
When the load increases during Silent mode, the tool will
automatically switch to Power mode and revert back to
Silent mode when the load decreases.
In Power mode, no change is made to Silent mode even
when the load decreases.
NOTE
○ To enable mode changes, pull the switch once after
connecting the main plug.
○ Do not give a strong shock to the switch panel or break it.
It may lead to a trouble.
MOUNTING AND OPERATION
Action
Fine tuning of parallelism
Fine tuning of perpendicularity
Fine tuning of guide piece position
Adjusting the cutting depth
Cutting line
Switch operation
About the mode select function (*1)
Using the LED light
Using the cord holder
Attaching the long guide
(sold separately)
Attaching the guide (sold separately)
Attaching the fl uorine plate
(sold separately)
Attaching the dust collection adapter
(sold separately)
Cutting at right angles
Inclined cutting (+45° direction)
5
English
Figure Page
9 151
10 151
11 151
12 152
13 152
14 152
15 152
16 152
17 152
18 153
19 153
20 153
21 153
22 153
23 154