Standard Accessories; Preparation Before Operation - Hitachi CC 14 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

STANDARD ACCESSORIES

Fig. 3
WARNING:

PREPARATION BEFORE OPERATION

Make the following preparations before operating the power tool:
1. Installation
Install the machine on a level flat place, and keep it in a stable condition.
2. Extension Cord.
Ampere rating
(on nameplate)
Ext. cord length
25 ft
(7.5 m)
50 ft.
(15 m)
100 ft.
(30.5 m)
NOTE: The lower the wire size number, the heavier the wire, and the farther it will carry
current without a voltage drop.
WARNING:
3. Take off the chain.
As the movable part is pulled down by a chain when shipping out, slightly push the
handle down and take off the chain from the handle.
q Cut-Off Wheel 14" × 7/64" × 1"(355 × 2.8 × 25.4 mm)
w Spanner
The use of attachment or accessories not recommended in this manual
may be hazardous.
12.1 to 16.0
Wire gauge size
A.W.G (mm
2
)
14 A.W.G
2
(2.0 mm
)
12 A.W.G
2
(3.5 mm
)
Not
recommended
Never connect this unit to an electrical power source until all operating
instructions have been read and understood.
Model CC 14 (A36RBIG) 1pc. (Code No.964975Z)
(Attached to the main body)
To use the power tool when no suitable power
source is nearby, use an extension cord of
suitable size to ensure safety, and to prevent
power loss and overheating.
Determine from the accompanying table the
required extension cord wire size.
Check power cord and extension cords for loose
or exposed wires and damaged insulation,
before using.
Repair or replace as needed, before using the
power tool.
English
9

Publicidad

Tabla de contenido
loading

Tabla de contenido