Deck Cutting Height Adjustment - HUSTLER X-ONE Manual De Instrucciones

Discharge chute may vary from this illustration
A
A. Discharge chute
Figure 3-12
Rear Discharge Decks – Never direct the discharge
of material from the mower deck toward bystand-
ers. Do not operate the mower without the rear dis-
charge rubber flaps or power unit deflector in
place. Figure 3-13
A
B
A. Rubber flaps
Figure 3-13
606528CE
A
B. Power unit deflector
Never attempt to make any adjustments to the
mower deck while the engine is running or with the
deck drive clutch engaged. Mower blades cannot
be seen and are located very close to the deck
housing. Fingers and toes can be cut off instantly.
Deck Clutch Operation
Before beginning operation, check to make sure the deck
clutch switch is engaging and disengaging the blades properly.
Make sure that the area around and under the deck
is clear and that there are no bystanders in the
immediate area before proceeding.
To check the deck clutch switch:
1. Start the engine and engage the deck clutch.
2. With the deck clutch switch up (clutch engaged) and
the engine running, listen to confirm that the mower
blades are rotating.
3. Now, push the deck clutch switch down (clutch disen-
gaged), and with the engine running, listen to confirm
that the blades have stopped rotating.
4. If the mower blades continue to rotate with the deck
clutch switch down, discontinue operation immedi-
ately and contact your Hustler
Follow these procedures to maximize clutch life:
1. Engage the clutch only when the throttle is set at
approximately 2/3 throttle and there is no load on the
blades. After clutch engagement, advance the engine
throttle to full rpm.
Engaging the deck clutch at high engine rpm or when
under heavy load (in tall grass, for example) can cause
belts and/or electric clutch to slip, resulting in premature
wear or possible damage.
2. Disengage the clutch only when the throttle is set at
less than 1/2 throttle.
Never disengage the clutch with the engine running at
high rpm. Setting the throttle to less than 1/2 throttle
when disengaging the clutch will help extend clutch life.
Warranty will not be allowed for deck clutches that fail due
to improper engagement and disengagement practices.

Deck Cutting Height Adjustment

The deck cutting height is adjustable in 6.3mm increments.
The holes in the height adjusting bar are spaced at 6.3mm
intervals. Figure 3-14
To set the deck cutting height:
3-9
Dealer.
®
REV B
CZ
DA
DE
EN
ES
FR
IT
NL
PT
SV