Troubleshooting; Technical Data - Cramer 82TB10 Guia Del Usuario

Troubleshooting

EN
POSSIBLE
PROBLEM
CAUSE
String is weld-
ed to itself.
Not enough
string on spool.
String will not
advance when using
String is worn
the bump-feed head.
too short.
String is tan-
gled on spool.
Grass wraps around Cutting tall
shaft housing and grass at ground
string head. level
Battery is not
secure.
Motor fails to start
when switch trigger
is depressed.
Battery is not
charged.
* If the fault is not solved, you must go to your distributor and/or nearest Authorized
Technical Service.
12
cramer.eu
SOLUTION
Replace string.
Install more string. Refer to string
replacement earlier in this manual.
Pull string while pressing line release
button.
Remove string from spool and
rewind. Refer to string replacement
earlier in this manual.
Cut tall grass from the top down to
prevent wrapping.
To secure the battery pack, make
sure the latch on bottom of the bat-
tery pack snaps into place.
Charge the battery pack according
to the instructions included with your
model.

Technical Data

PROPERTY
82TB10
Model
4500-5500-6000-
No load speed
6500 rpm ±10%
Cutting head Bump feed
Cutting Line Diameter 2 mm
Cutting Path Diameter 40 cm
82V220G/82V430G/
Battery pack
82V220/82V430
Charger 82C1G/82C2/82C6
Weight (without battery pack) 5.5 kg
Measured sound L
pressure level K
Measured sound
L
power level
Lawn
Trimmer
Guaranteed sound
95 dB(A)
power level
< 2.5 m/s
Vibration
k=1.5m/s
VALUE
VALUE
82TB16
4500-5000-5500-
6300 rpm ±10%
Bump feed
2 mm
46 cm
82V220G/82V430G
82V220/82V430
82C1G/82C2/82C6
5.83 kg
= 7 4 . 5 2 d B ( A ) , L =72.18 dB(A),
PA PA
=3 dB(A) K =3 dB(A)
PA PA
=94.52dB(A) L =92.18 dB(A)
WA WA
96 dB(A)
2 2
, < 2.5 m/s ,
2 k=1.5m/s 2