Honeywell 9000 Guia Del Usuario página 23

Changing system setup
System Setup Options (concluded)
Screen Title
Your heating
system type
Number of cooling
stages
Number of heating
stages
Your fan control
Type of changeover
valve
Number of heat
pump compressor
stages
Your backup heat
System setup
Note: Your contractor already setup
your thermostat. You should not need
to perform any setup. Follow these
instructions only if you do a factory reset.
Before connecting to your Wi-Fi network,
you need to set initial thermostat options
to define your heating/cooling system:
• Language
• Home or business
You can customize other options later.
Follow prompts on the screen to select
appropriate options.
1 Touch the language you want the
thermostat to display, then touch Next.
2 Select Home or Business installation,
then touch Next.
69-2814EFS—07
Settings and Options
If you selected Hot Water or Steam on "Your system type," select the
specific heating system here.
Select 1 Stage (default) or 2 Stages. If you are unsure, note which
wires are connected: 'Y' wire only (1 stage) or 'Y' and 'Y2.'
Select 1 Stage (default) or 2 Stages. If you are unsure, note which
wires are connected: 'W' wire only (1 stage) or 'W' and 'W2.'
Select whether your thermostat (default) or heating system controls
the fan.
If you selected Heat Pump on "Your system type," select whether it
uses a cooling changeover valve (default) or heating changeover valve.
f you are unsure, note which wires you have connected.
Select 1 Stage (default) or 2 Stages. If you are unsure, note which
wires are connected: 'Y' wire only (1 stage) or 'Y' and 'Y2.'
No or Yes (default) you can determine whether you have backup heat.
21
Next
Next