DeWalt D25133 Manual De Instrucciones página 25

3. Release the button to lock rod into position. When
drilling with the depth rod, stop when end of rod
reaches surface of material.
Fig. D
7
OPERATION

WARNING: Always observe the safety instructions
and applicable regulations.

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.

WARNING: To reduce the risk of personal injury,
ALWAYS ensure workpiece is anchored or
clamped firmly. If drilling thin material, use a wood
"back-up" block to prevent damage to the material.

WARNING: To reduce the risk of personal injury,
ALWAYS operate the tool with the side handle
properly installed and securely tightened. Failure
to do so may result in the side handle slipping during
tool operation and subsequent loss of control. Hold
tool with both hands to maximize control.
Proper Hand Position (Fig. E)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the
side handle 8 , with the other hand on the
main handle .
2
Fig. E
9
8
Drilling Tools
The machine is intended for hammerdrilling in concrete,
brick and stone. It is also suitable for drilling without impact
in wood, metal, ceramic and plastic.
Chipping Tools
The machine is intended for chipping in concrete, brick
and stone.
Chipping and Chiseling (Fig. A)

WARNING: Do not operate in drill or hammerdrill
mode with a chisel bit in the chuck. Personal injury
and damage to tool may result.
1. Insert chisel while in hammerdrill mode and rotate to
desired position.
2. Set the mode selector
3. Adjust the side handle
4. Switch on the tool and start working.
5. Always switch off the tool when work is finished and
before unplugging.
Mechanical Clutch
All rotary hammer drills are equipped with a torque
limiting clutch that reduces the maximum torque reaction
transmitted to the operator in case of jamming of a drill bit.
This feature also prevents the gearing and electric motor
from stalling. The torque limiting clutch has been factory-set
and cannot be adjusted.

WARNING: Drill may stall if overloaded causing a
sudden twist. Always expect the stall. Grip the drill
firmly with both hands to control the twisting action
and avoid injury.
Operation Modes (Fig. F)

WARNING: Do not select the operating mode when
the tool is running.

CAUTION: Never use in Rotary Drilling or Rotary
Hammering mode with a chisel bit in the bit holder.
Personal injury and damage to the the tool may result.
Your tool is equipped with a mode selector dial to select the
mode appropriate to desired operation.
ENglIsh
2
8
4 to the hammer-only position.
8 as required.
23