Clatronic KA 2534 Instrucciones De Servicio página 31

36901-05-KA 2534/KA 2535
Electrical Connection
• Make sure that the machine is switched off (operating switch on "OFF").
• Before inserting the mains lead into the socket, check whether the voltage you
intend to use complies with that of the machine.
For details see the machine label.
• Only connect the machine to a properly installed safety socket, 230 V/50 Hz.
Operation for models without a timer
1. Pull the lid of the water tank forwards. Fill the machine to the level corresponding
to the number of cups required with cold water.
2. Turn the filter to the left. Place a paper filter (size 1 x 4) into the filter funnel and
fill it with coffee powder (approx. 1 teaspoon for 2 cups). Then close the filter hol-
der until it locks in place.
3. Place the pot on the hot plate and close the lid of the water tank.
4. Move the switch to the "EIN/1" position. The coffee takes approximately 10 - 15
minutes to boil. When no more coffee is running into the pot it can be removed.
If you would like to keep the remaining coffee warm, the switch must remain in the
"EIN/1" position. The hot plate will keep the coffee warm until you switch the machi-
ne "AUS/0".
Switching Off
The machine is switched off when the switch is in the "AUS/0" position.
Operation for models with a timer
Items 1 – 3 are identical for models without a timer.
4. Press the EIN/AUS (ON/OFF) switch twice. The green LED comes on and the
unit is switched on. The unit switches off by itself after approx. 2 hours.
The unit is switched off when both LEDs are off.
If you wish to switch the unit off manually or to deactivate the timer, press the
EIN/AUS button repeatedly until both LEDs go out.
Operation of the timer:
1. Set the time
Set the hours:
Set the minutes:
2. Set the switching time
Hold down the "SET" button.
Set the hours:
Set the minutes:
28.08.2003 10:03 Uhr
press the "STD" button.
press the "MIN" button.
press the "STD" button.
press the "MIN" button.
Seite 31
GB
31