Operating Instructions - Kapro PROLASER 875 Manual Del Usuario

OPERATING INSTRUCTIONS

Working in Automatic mode (self-leveling):
In automatic mode the laser level, will level itself in the range of
± 2.5° and will project 1 horizontal ,4 vertical lines, and 1 plumb
dot. These lines will create 1 cross lines on the wall, and a second
cross lines on the ceiling.
1. Remove the laser from the case and place it on a solid flat, and
free vibration surface, or on a tripod.
2. Adjust the unit's support legs (#6), or the tripod legs, until the
surface level (#4) is centered.
3. Turn the pendulum safety lock (#12) clockwise to the ON
position. The surface level at the center of the keypad (#4) will
light. The cross beams forward, and plumb dot will be projected.
4. To direct the beams to the desirable position turn the laser and
use the fine – adjustment knobs (#5), for the precise position.
5. Press the push button V (#2), the rear vertical beam will be
projected too.
6. Additional click on the push button V (#2) will add the 2 sides
vertical beams. This will create additional cross beams above
the laser.
7. Additional click on the push button V (#2) will turn off all vertical beams.
8. Press the push button H (#1) to turn off or on the horizontal beam.
9. If the initial level of the laser is beyond ± 2.5°, the laser beams
will flash, and a beep alarm will be heard. In this case reposition
the laser on a more leveled surface.
10. Before moving the laser level, turn the pendulum safety
lock (#12) anti-clockwise to the OFF position. This will lock the
pendulum, and protect your laser.
11