Cleaning And Caring For The Camera - Waeco PerfectView CAM55 Instrucciones De Montaje

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 51
PerfectView CAM55, CAM55W
➤ Guide the camera cable into the vehicle interior.
➤ Insert the plug of the camera cable into the socket of the extension cable.
➤ Screw on the plug connections of the connecting cables to protect against
water penetration (fig. g, page 6).
Aligning the camera
I
NOTE
If necessary before aligning the camera connect the camera to a
monitor and to a power supply (see connecting diagram, fig. h,
page 6)
➤ Use the monitor image to align the camera:
The monitor image should show the bottom edge of the rear or the
bumper of your vehicle (A). The middle of the bumper should be in the
middle of the screen. (fig. i, page 6).
➤ Check the function of the camera after you have connected it to a monitor.
Fastening the camera
➤ Tighten the two fastening screws in the holes at the side camera holder.
➤ Click the side covers into the openings at the side provided for this pur-
pose (fig. j, page 7) and fasten them in place by turning them.
➤ To remove the side covers, insert two blunt and flat objects into the
openings on the covers provided for this purpose, and turn them.
9

Cleaning and caring for the camera

A
NOTICE! Risk of damage!
Do not use sharp or hard objects to clean the device as these may
damage the device.
➤ Clean the camera with a soft, damp cloth from time to time.
EN
Cleaning and caring for the camera
33

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Perfectview cam55w

Tabla de contenido