Selecting Dts Surround - Aiwa AV-DV95 Manual De Instrucciones

SELECTING DTS SURROUND
The optimal DTS surround modes and settings depend on the
typeand placement of thespeakers. Itisrecommended thatthe
optional Aiwa speakers should be used for ail channels, for
example, the SX-AVR2700 speaker system.
Check the current type and placement of your speakers and select
the recommended mode accordingly.
The recommended mode
Center speaker No
centerspeaker
Surround speaker
5.lch 4 ch
(Rear sDeaker)
No surround
3 STEREO 2chSTERE0
speaker
Before playing a disc, adjust the speaker level balance in Dolby
Digital or Dolby Pro Logic mode as described in page 16.
To adjust the balance while listening to the source, see the
right column in page 17 and follow the steps 2 and 3. The delay
time of the center and surround speakers cannot be adjusted in
DTS surround mode.
m
Depending on the sound source or listening condition, surround
effect may not be obtained even when the DTS surround is
selected.
The full DTS surround effect cannot be obtained when using
software not recorded in the DTS surround system. In this case,
use the DSP surround system instead (see page 10).
When headphones are plugged in, DTS surround mode is
automatically changed to "2chSTERE0."
QWhile headphones are plugged in, DTS surround mode cannot
be changed.
4 ch mode: Select this mode when the center speaker is not
connected. AH center channel signals are redistributed to the
left and right channel speakers.
To listen to the original DTS sound
3 STEREO mode: Select this mode when the surround speakers
are not connected.
When the DTS is appears on the display, all the sound settings
can be canceled for DTS sound.
1 While the DTS surround is activated, press the
ENTER button on the main unit and hold it down
TO SELECT A DTS SURROUND MODE
until "BYPASS OFF" runs through on the display.
11
Preparation
When selecting a DTS surround, select the CD function and
play a disc recorded in DTS surround before selecting the
mode.
1 Press the SURROUND button and turn the MULTI
JOG to select the appropriate mode.
The selected mode name appears on the display.
..... .
;;.
.... .: ... :...
;:"
.;
. . ..- :: .:. . . . . . .
mmmimkmi
@
Gm.1.ru
F@
~ 5.ICH —-----+4ch
— 3 STEREO
7
ad
rmmmmmmmim'a ; ;
,@
mxKlaQEI QEzimmEicEm , : ,
.... . . .... ... .... ... ... ..... ..... :
!
;-t.:: :: :: ::
:,mm ; ;: ... ;., . , : :
. . ....
:m..: . . .
., . .
imrtim
@
"""' : : : """"'""--"""'":
13mol.avl
@@
2 Press the UP or DOWN button or turn the MULTI
JOG to display "BYPASS ON."
:... . ..... ... .... ... ... . :
::
;,:: :
:: ::
:.., :::.,.:
:... . . :... :...::...
;,m.~:..: .
; ; :
:Omo,
:,m. o :
.:
mmmrmsim
~
L..'
@d
DIGWAL FQ
To
restore the sound settings
Repeat steps 1 and 2 so that "BYPASS OFF" appears.
To select the 2chSTERE0 mode, press the SURROUND
button repeatedly until "2chSTERE0 appears.
19
ENGLISH