Waeco MagicSafe MS650 Instrucciones De Montaje Y De Uso página 47

MS-650.qxd 13/08/03
Electrical connection / plug connections, P2 (see ✎ D 2)
P2.5 RED/BLACK
P2.6 BLUE/RED
To identify the switching functions of the original central door locking, you
need the wiring diagram of the central door locking. The diagrams are
available at the car dealer's.
Please look at the following wiring diagrams for the most common
central-door locking-system.
Electrical connection / harness, P3 (see ✎ D 3)
BROWN/WHITE (P3.2)
This is an activated signal output (low when the alarm is activated). The
output switches against earth when the device is activated and may be
loaded with maximum 200 mA. (Additional relay necessary).
GREEN (P3.3)
The connection of the green wire will also depend upon the type of door
switching-circuit used by the vehicle. If the vehicle has negative door
switches – the door wire connects to earth when the door is opened –
then connect the green wire to earth.
The connection of the green wire will depend upon the type of the door
switching used by the vehicle.
If the vehicle has positive door switches – then connect the green wire to
the door wire (see ✎ E 1 and E 2).
YELLOW (P3.4)
The connection of the yellow wire will also depend upon the type of door
switching-circuit used by the vehicle. If the vehicle has negative door
switches – the door wire connects to 12 volts (battery feed) when the
door is opened – then connect the yellow wire to a permanent 12 volt
battery feed.
If the vehicle has positive door switches – the door wire connects to +12
12:58 Page 47
unlock normally open
unlock together
47