Working Phase - OP UNISPEED US-FL/01 MAN Manual De Uso

OP
S.r.l.
25131 BRESCIA - Via Serpente 97 - Tel.030/3580401 - Fax 030/3580838
_________________________________________________________________________
•
•
•
FOR FLARING PIPE TO 37° FOR SAE-JIC COUPLINGS:
•
LIFT THE PIPE STOP RETAINER AND FIT THE FLARING PUNCH ON THE
•
PISTON ROD KEEPING IT CLEAN AND LIGHTLY GREASED (RECOMMENDED
TYPE OF GREASE KLUBER STABURAGS NBV30).
LOCK THE PUNCH ONTO THE ROD USING THE SAFETY PIN PROVIDED.
•
•

WORKING PHASE

MACHINE CHARACTERISTICS
•
SAFETY REGULATIONS
•
PREPARING THE MACHINE
•
HANDLING/TRANSPORT
•
LIGHTING
•
Make sure that the pipe to be machined has been thoroughly deburred inside
and out
PREFITTING RINGS ON DIN 2353 COUPLINGS:
ATTENTION: for the pre-assemmling of the washers, please view the pressures
listed on the table A
31
E
N
G
L
I
S
H