Introduction; Description - Chauvin Arnoux Y4N Manual De Instrucciones

The Y4N 1 mV DC/A AC current clamp is designed for alternating current measurements in low-
voltampere systems, from 2 A to 500 A AC (up to 600 A AC max - see chapter 4.3.1).
The asymmetrically shaped jaws clamp around cables or busbars.
The Y 4N connects to any multimeter, recorder, etc. having a DC voltage input with an impedance of
10 MΩ or more.
It features dual or reinforced insulation and conforms to international standards, such as EN 61010-2-032
"Current clamps" (see chapter 4.4).
(See drawing § 7. Appendix )
Overall dimensions: 195 x 66 x 34 mm
Weight: 420 g
➀
Jaw opening: 33 mm
Height with jaws open: 96 mm
➁
4 centring marks
Max clamping capacity: 30 mm dia. cable and 63 x 5 mm busbar
➂
I arrow indicating the direction of current flow. The current is considered to flow in the positive
direction when flowing from the "current producer" to the "current consumer". This orientation of the
current clamp is required during a power measurement (current measured concurrently with voltage).
➃
Cable length: 1,5 m
➄
Output via two 4 mm dia. safety elbow plugs.

1. INTRODUCTION

2. DESCRIPTION

11