Switching Off - Trotec PC200 Manual De Instrucciones

Cleaning the sensor (internal calibration)
If the device is used in heavily contaminated environments, the sensor must be
cleaned with the supplied zero filter.
Proceed as follows to do so:
1. Unscrew the metallic measuring funnel from the device.
2. Screw the calibration hose onto the suction nozzle and attach the zero filter.
3. Now, carry out a measurement in the "Cumulative" particle measurement
mode until "0" is shown in each channel.
4. The calibration process should not take more than 5 minutes.
If the desired values of zero are not reached in all channels within that time,
please contact the TROTEC

Switching off

1. Hold down the "On/Off" button
– The device has switched itself off.
2. Slide up the protective cap of the temperature sensor.
Connecting a USB cable
Saved measurement logs, photos and videos can be transferred to a PC with the
supplied USB cable.
To connect the USB cable to the device, proceed as follows:
1. Open the rubber side cover.
2. Connect the USB cable to the device.
B - 6
®
service department.
until the colour display turns off.
Inserting a MicroSD card
The storage capacity of the device can be expanded by using a MicroSD card. To
insert a MicroSD card, proceed as follows:
1. Switch off the device.
2. Unscrew the battery compartment screw and open it.
3. Remove the battery.
4. Open the cover for the memory card.
5. Insert a memory card and close the cover.
6. Put the battery back in.
7. Close the batter compartment and screw it closed again.
Operating manual – Particle counter PC200
GB