Technical Data; General Warnings - Rupes SR100AEN Instrucciones De Uso

TECHNICAL DATA

TYPE
PROTECTION CLASS
OPERATING VOLTAGE
ABSORBED CURRENT
ABSORBED POWER
OVERLOAD PROTECTION
ELECTRONIC SPEED CONTROL
RPM
ROLLER DIAMETER mm
THREAD OF ROLLER BEARING SHAFT
RETAINER OF ROLLER BEARING SHAFT
WEIGHT Kg

GENERAL WARNINGS

The tool must be connected to a suitable dust extraction system (not supplied).
SAFETY AND ACCIDENT PREVENTION INSTRUCTIONS
The safety and accident prevention instructions are reported in the
"SAFETY INSTRUCTION" booklet which forms an integral part of the-
se documents; the operating instructions indicate the additional infor-
mation required specifically for use of the tool.
Never use the tools without the safety guards.
Any operations carried out on the tool must be effected with the
power supply disconnected.
Before starting the tool, ensure that it is held tightly and not in contact
with the work surface.
Wear clothing suited to the work you are about to perform.
Always work with the protective suction hood assembled.
Make sure that the abrasive rollers have been assembled and
tightened properly.
Make sure that the sparks caused during work do not create danger
by hitting people or inflammable substances.
Hazardous dust may form during use regulation safety devices for
personal protection and observe safety norms valid for the processed
work material.
8
SR100AEN
II
230 V – 50 HZ
4,3 A
900 W
YES
YES
1500÷4000
100
M 14
M8 SCREW
2,6
Remember to always use all personal protection devices (such as
gloves, headphones, goggles, etc.) according to laws in force to
prevent or reduce accident probability.
Warning! the appliance continues to work for a few seconds after it
has been switched off!
SPECIFIC USE
Before use make sure that the abrasive rollers operating characteri-
stics are compatible with those of the machine and that they are not
broken or worn.
Make sure that the abrasive rollers are assembled, handled and sto-
red with care according to the manufacturer's indications.
Do not use and adapter system for abrasive rollers other than those
specified.
Make sure the work piece is sufficiently fastened.
In the event of improper use, the user is fully liable for any damages or
accidents.
ENGLISH
8
SR200AE
II
230 V – 50 HZ
5,3 A
1.100 W
YES
YES
1500÷4000
100
M 14
M8 SCREW
2,8