Sears Kenmore 148.16154210 Manual De Uso Y Cuidado página 15

UNPACKING
After removing all parts and hardware pack from the top of the shipping box, and when the only part showing is
the grill head, use a ox cutting knife to slice down the sides of the box. Be careful of staples along shipping box
b
edges.
Remove the corner supports from the box and the styrofoam side pieces from the grill head. Allow grill head to
rest on cardboard until placing grill head on cart in Step 7.
Open grill lid and remove all packaged parts and packing material.
WARNING: Assemble the grill on a flat level surface. Compare the parts and hardware with the list and
diagrams. Do not attempt assembly if any part is missing or damaged.
Insert the casters into the holes of the bottom panel, and then tighten with wrench from the hardware
pack. When this process is completed, turn the bottom panel right side up. The two locking casters
should be at the back of the grill.
Loosen the two screws at the back of the bottom panel 3 to 4 turns.
Place the holes in the base of the rear panel over the two loosened screws and slide the panel to the
left until it stops. Retighten the screws.
Bottom Panel
Bottom Panel
Caster
Locking Caster
Rear panel
15