Eaton iLumin Plus Serie Manual De Instalación página 5

To Mount the Enclosure
1. Choose a dry location convenient to the circuit breaker
panel that meets the operating temperature requirements.
2. Mount the panel on a firm surface using the predrilled
holes.
3. Connect the enclosure to the circuit breaker panel using
conduit.
4. Remove all cuttings and dirt.
Note: Make certain that high voltage and low voltage load
wiring enters the enclosure separately. High voltage wiring
should be brought into the enclosure through the left and
right sides or the top right and top left wiring channels. Low
voltage wiring can be brought into the enclosure from the
top-middle or bottom middle location of the enclosure.
Note: Ensure at least three(3) inches of air space around the
iLumin Plus enclosure.
3 INCH SPACE AROUND ENCLOSURE PANEL
12.00
6.00
Ă .25
2X
SMALL
Wiring Flow
All cabinets have been designed to provide a clear layout and
logical progression for all power circuits.
The main supply conductors enter at the top panel. Input
power is then fed to the modules inside the cabinet.
Field wiring for branch circuits that are connected to the
SCMR relay modules also enter from the top of the cabinet.
Ground connections are provided at the top of the cabinet
for landing grounding conductors.
Note: Check the stated voltage rating of the controller
before connecting to the supply and check that it matches
the supply voltage. All cabinets are 120-277V universal input
3 INCH SPACE AROUND ENCLOSURE PANEL
16.00
.25
2X
Ă .44
2X
3.75
8.75
MEDIUM
Ă .91
8.00
2X
.41
2X
10.75
22.88
Ă .41
2X
Class 2
Low voltage Input
3 INCH SPACE AROUND ENCLOSURE PANEL
16.00
8.00
Ă .91
.41
2X
2X
15.38
32.14
Ă .41
2X
LARGE
Class 1 and Class 2
High and Low voltage Input/Output
Class 1 and Class 2
High and Low voltage Input/Output
www.eaton.com/lighting
iLumin Plus
Class 2
Low voltage Input
5