Troubleshooting - Hayward LPCUS11 Serie Manual De Uso

If you have a problem with your Hayward Universal ColorLogic/CrystaLogic light, please try the following tips before calling for service:
PROBLEM: Universal ColorLogic Light will not advance to the next program when it is power-cycled (turned "off" and then back "on").
SOLUTION1: Do not power-cycle the switch too rapidly. Leave it off for at least 1 second before turning it back on.
SOLUTION2: Make sure that the light is in the proper mode (page 12).
PROBLEM: Universal ColorLogic Light goes to white whenever it is power-cycled (turned "off" and then back "on").
SOLUTION: Be sure that you power-cycle the light for less than 10 seconds.
PROBLEM: Multiple Universal ColorLogic Lights are not correctly synchronized.
SOLUTION: Verify that the Universal ColorLogic light is in the proper mode (page 12). Follow the steps in these instructions to re-synchronize the lights.
PROBLEM: Light will not come on.
SOLUTION: Check input power to transformer and then light. Check ground fault and reset if necessary.
PROBLEM: Light will not come on or light cycles on and off.
SOLUTION: Depending on cord length and operating voltage, automatic thermal switch may be cycling due to excessive air/pool water temperatures (over
105ºF). Temporarily switch to a cooler color (Deep Blue Sea, Royal Blue, etc.) until air/water temperatures cool off.
PROBLEM: GFCI trips when lights are turned on or off.
SOLUTION: Install a Hayward GLX-HAL-XSNUB snubber capacitor across the primary leads (line to neutral) of the transformer on the load side of the light
switch or relay.
To original purchasers of this equipment, Hayward Pool Products, Inc. warrants its Universal ColorLogic
lights, niches, pool light transformers, and couplers to be free from defects in materials and workmanship for a period of ONE (1) year
from the date of purchase, when used in single family residential applications.
The limited warranty excludes damage from freezing, negligence, improper installation, improper use or care or any Acts of God. Parts
that fail or become defective during the warranty period shall be repaired or replaced, at our option, within 90 days of the receipt of
defective product, barring unforeseen delays, without charge.
Proof of purchase is required for warranty service. In the event proof of purchase is not available, the manufacturing date of the product
will be the sole determination of the purchase date.
To obtain warranty service, please contact the place of purchase or the nearest Hayward Authorized Service Center. For assistance on
your nearest Hayward Authorized Service Center please visit us at www.hayward.com.
Hayward shall not be responsible for cartage, removal, repair or installation labor or any other such costs incurred in obtaining warranty
replacements or repair.
The Hayward Pool products warranty does not apply to components manufactured by others. For such products, the warranty estab-
lished by the respective manufacturer will apply.
The express limited warranty above constitutes the entire warranty of Hayward Pool Products with respect to its' pool products and is in
lieu of all other warranties expressed or implied, including warranties of merchantability or fitness for a particular purpose. In no event
shall Hayward Pool products be responsible for any consequential, special or incidental damages of any nature.
Some states do not allow a limitation on how long an implied warranty lasts, or the exclusion of incidental or consequential damages, so
the above limitation may not apply to you. This warranty gives you specific legal rights, and you may also have other rights, which vary
from state to state.
14

Troubleshooting

Hayward Pool Products Limited Warranty
®
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
and CrystaLogic pool and spa
® TM