Surface Temperatures; Ambient Temperature; Displaying Stored Measurements - innohaus AFT 58 Instrucciones De Uso

Surface temperatures:

To measure surface temperatures, change the thermometer to Surface Temperature Mode.
1. Remove the Protective Cover from the sensor.
2. Press the ON/OFF Button to turn the thermometer on.
3. Change the thermometer to surface temperature mode by pressing and hold-
ing the ON/OFF Button and START Button at the same time. The surface tem-
perature mode icon "
4. Hold the sensor tip of the ear thermometer 0.4-0.8 inch (1 – 2 cm) from the surface to be measured
and press the START Button.
5. After one second, the thermometer will beep once and display the measure-
ment. Press the ON/OFF button to shut the thermometer off.

Ambient temperature:

When the thermometer powers on, the ambient temperature, date, and time will alternate on the LCD
Display.

Displaying stored measurements:

The ear thermometer stores the last 10 ear and surface temperatures, along with the measurement date and
time. To recall stored measurements, proceed as follows:
" will display.
8