Care And Maintenance; Troubleshooting Guide; Error Message - innohaus AFT 58 Instrucciones De Uso

1. Press the ON/OFF button to switch the thermometer on.
2. Press and hold the ON/OFF button for three seconds;
"MEM" and the last stored measurement will appear on
the LCD Display.
3. To view stored measurements, press the ON/OFF Button
to cycle; the memory number is displayed first followed
by the measurement.
4. To proceed with a new measurement, press the START Button; otherwise, press and hold the ON/OFF
button for three seconds to shut the thermometer off.

6. Care and Maintenance

• Protective Covers are intended for a single use only. Discard after each use.
• The sensor is the most sensitive part of the thermometer. Work carefully when
cleaning the sensor to avoid product damage. Use a clean cloth or cotton swab
moistened with disinfectant, alcohol, or warm water.
• To clean the outer surface of the thermometer, use a soft cloth slightly moistened
with a mild soapy solution.
• Do not use any harsh cleaning products.
• Before prolonged storage, remove the batteries.
• Do not use or store the device in excessively high or low temperature or humidity (see technical data), in
direct sunlight, near an electrical current or in dusty locations.
• Clean the sensor tip after every use. Use a clean cloth or cotton swab that can be moistened with rubbing
alcohol or warm water.
• To clean the device, use a soft, damp cloth and a mild detergent. Ensure water does not get into the
device. If the device does get wet, remove the battery immediately and let dry completely before reuse.
• Never immerse the device in water.
• To protect the sensor tip, always replace protective cover after use.
• When storing the device for an extended period, remove the battery.

7. Troubleshooting Guide

Error message

Problem
Autotest in progress, device not ready. Retry measurement. Take measurements
Solution
only once body ( ) or object temperature
mode ( ) appears on the display.
9
->